Zizhen Ma1, Zhen Li1, Jingkun Jiang1, Jianguo Deng1, Yu Zhao 2, Shuxiao Wang1, Lei Duan 1

  • 1 State Key Laboratory of Environmental Simulation and Pollution Control, School of Environment, Tsinghua University, Beijing 100084, China
  • 2 School of the Environment, Nanjing University, Nanjing 210023, China

Received: May 17, 2016
Revised: August 20, 2016
Accepted: September 3, 2016
Download Citation: ||https://doi.org/10.4209/aaqr.2016.05.0200  

  • Download: PDF


Cite this article:
Ma, Z., Li, Z., Jiang, J., Deng, J., Zhao, Y., Wang, S. and Duan, L. (2017). PM2.5 Emission Reduction by Technical Improvement in a Typical Coal-Fired Power Plant in China. Aerosol Air Qual. Res. 17: 636-643. https://doi.org/10.4209/aaqr.2016.05.0200


HIGHLIGHTS

  • Advanced combustion technology decreases PM2.5 emission factor by 20%.
  • PM2.5 emission was reduced for the application of cold-side ESP.
  • Some air pollution control devices may increase emission of SO42– and Ca2+.

 

ABSTRACT


To investigate PM2.5 reduction by technical improvement in typical Chinese coal-fired power plants, two units built in different time with different particulate matter (PM) control technologies but with the same coal-fired boiler type were selected to characterize the concentrations of PM2.5 generated and emitted from coal-fired power plants. We found that significant benefit of PM2.5 emission reduction was achieved by technological improvement. Due to the increase in the installed capacity and the application of low NOx burner alone, PM2.5 emission factor without adopting other air pollution control devices decreased from 0.153 kg t–1 (the 100 MW unit) to 0.123 kg t–1 (the 300 MW unit). With the help of an improved electrostatic precipitator (ESP) of which removal efficiency increased from 76.4% to 97.5%, PM2.5 emission factor further decreased from 0.014 kg t–1 (the unit with a normal ESP) to 0.003 kg t–1 (the unit with a cold-side ESP and a wet flue gas desulphurization (WFGD)). However, the application of flue gas denitrification and desulfurization devices may alter PM2.5 compositions and their emissions. For instance, the installation of a WFGD was found to largely increase the emissions of water-soluble ions in PM2.5 (e.g., SO42–, Ca2+, and NH4+).


Keywords: PM2.5; Emission factor; Coal-fired power plant; Water-soluble inorganic ion; Wet flue gas desulphurization (WFGD)

Don't forget to share this article 

 

Subscribe to our Newsletter 

Aerosol and Air Quality Research has published over 2,000 peer-reviewed articles. Enter your email address to receive latest updates and research articles to your inbox every second week.