Qianyun Chang1, Chenghang Zheng1, Xiang Gao 1, Penchi Chiang2, Mengxiang Fang1, Zhongyang Luo1, Kefa Cen1

  • 1 State Key Laboratory of Clean Energy Utilization, Zhejiang University, Hangzhou, China
  • 2 Graduate Institute of Environmental Engineering, National Taiwan University, Taipei, Taiwan

Received: June 24, 2015
Revised: August 30, 2015
Accepted: August 30, 2015
Download Citation: ||https://doi.org/10.4209/aaqr.2015.06.0418  

  • Download: PDF


Cite this article:
Chang, Q., Zheng, C., Gao, X., Chiang, P., Fang, M., Luo, Z. and Cen, K. (2015). Systematic Approach to Optimization of Submicron Particle Agglomeration Using Ionic-Wind-Assisted Pre-Charger. Aerosol Air Qual. Res. 15: 2709-2719. https://doi.org/10.4209/aaqr.2015.06.0418


HIGHLIGHTS

  • An ionic-wind-assisted pre-charger was designed for particle agglomeration.
  • Effects of perforated plate porosity on particle agglomeration was discussed.
  • Effects of discharging voltage match on particle pre-charging was discussed.
  • An optimal solution was achieved for particle agglomeration and collection.

 

ABSTRACT


Electric agglomeration is the process in which particles are charged in electric fields and coagulate, which is enhanced by electric force or turbulence. The collection efficiency of submicron particles is improved, which can be a solution to submicron particle abatement in traditional electrostatic precipitators (ESPs), by using a pre-charger to increase median particle diameter and realizing particle pre-charging. In this study, a laboratory bipolar pre-charger with a perforated plate between discharging regions was designed to examine ionic-wind-assisted charge-induced agglomeration, and an ESP was arranged afterwards to collect the fine particles. Experiments were conducted to investigate submicron particle charging, agglomeration characteristics, and collection efficiency. Results indicated that a pre-charger with proper discharging voltage match and plate porosity can optimize particle agglomeration and improve collection efficiency by about 12% compared with the results obtained without a pre-charger. An optimal solution was achieved and a collecting efficiency of 96%–98% was obtained for all sizes by utilizing the turbulence caused by ionic wind and optimizing the experimental operation conditions.


Keywords: Particulate matter; PM2.5; Bipolar pre-charger; Electric agglomeration; Electrostatic precipitator

Don't forget to share this article 

 

Subscribe to our Newsletter 

Aerosol and Air Quality Research has published over 2,000 peer-reviewed articles. Enter your email address to receive latest updates and research articles to your inbox every second week.