Elisabeth Alonso-Blanco1, Ana I. Calvo2, Véronique Pont3, Marc Mallet3, Roberto Fraile 4, Amaya Castro4

  • 1 Centro de Investigaciones Energéticas, Tecnológicas y Ambientales (CIEMAT), 28040 Madrid, Spain
  • 2 Centre for Environmental and Marine Studies (CESAM), University of Aveiro, 3810-193 Aveiro, Portugal
  • 3 Laboratoire d'Aérologie/OMP, UMR 5560, Université de Toulouse III, CNRS-UPS, 14, av. E. Belin, 31400 Toulouse, France
  • 4 Departamento de Física. IMARENAB. Universidad de León, 24071 León, Spain

Received: May 17, 2013
Revised: October 7, 2013
Accepted: October 7, 2013
Download Citation: ||https://doi.org/10.4209/aaqr.2013.05.0163  

  • Download: PDF

Cite this article:
Alonso-Blanco, E., Calvo, A.I., Pont, V., Mallet, M., Fraile, R. and Castro, A. (2014). Impact of Biomass Burning on Aerosol Size Distribution, Aerosol Optical Properties and Associated Radiative Forcing. Aerosol Air Qual. Res. 14: 708-724. https://doi.org/10.4209/aaqr.2013.05.0163



The influence of biomass burning on aerosol size distributions, particle number and radiative forcing has been studied at a rural site in Spain. It has been found that air contaminated by aerosols from biomass burning presents four times the total number of particles registered in non-contaminated air. In the case of the smallest fraction of the fine mode, between 0.1 and 0.2 µm, the increase soars to over seven times the total number of particles. An analysis of the evolution of the count mean diameter in the fine mode (CMDf) in the 8 daily measurements has revealed a decrease of over 25% in this parameter in the modified measurements when compared with measurements that were not contaminated by aerosols from biomass burning. In contrast, when the aerosol transport time is long, the increases detected in CMDf range between 15% and 100% when compared with measurements of air by non-aged aerosol from biomass burning. Shortwave radiative forcings have been calculated for these high loads of fine aerosols with GAME (Global Atmospheric Model) software. For the August event, the daytime average of surface radiative forcing is –66 (±30) W/m2, and at the top of the atmosphere the forcing is –32 (±12) W/m2. Induced daytime average of atmospheric radiative forcing reaches 34 (±20) W/m2. The study demonstrates that wildfires affect not only the number of particles and the size distribution, causing a clear increase in the number of aerosols in the atmosphere, but they are also responsible for altering the local radiative balance.

Keywords: Aerosol optical properties; Aerosol size distribution; Biomass burning; Radiative forcing; Aerosol optical counter

Share this article with your colleagues 


Subscribe to our Newsletter 

Aerosol and Air Quality Research has published over 2,000 peer-reviewed articles. Enter your email address to receive latest updates and research articles to your inbox every second week.

81st percentile
Powered by

2020 Impact Factor: 3.063
5-Year Impact Factor: 2.857

Aerosol and Air Quality Research (AAQR) is an independently-run non-profit journal that promotes submissions of high-quality research and strives to be one of the leading aerosol and air quality open-access journals in the world. We use cookies on this website to personalize content to improve your user experience and analyze our traffic. By using this site you agree to its use of cookies.