Abdallah A. Shaltout 1,2, Johan Boman3, Dhaif-allah R. Al-Malawi1, Zuhair F. Shehadeh1

  • 1 Physics Department, Faculty of Science, Taif University, 21974 Taif, P.O. Box 888, Saudi Arabia
  • 2 Spectroscopy Department, Physics Division, National Research Center, El Behooth Str., 12622 Dokki, Cairo, Egypt
  • 3 Department of Chemistry and molecular biology, Atmospheric Science, University of Gothenburg, SE-412 96 Göteborg, Sweden

Received: November 20, 2012
Revised: March 14, 2013
Accepted: March 14, 2013
Download Citation: ||https://doi.org/10.4209/aaqr.2012.11.0320  

  • Download: PDF


Cite this article:
Shaltout, A.A., Boman, J., Al-Malawi, D.a.R. and Shehadeh, Z.F. (2013). Elemental Composition of PM2.5 Particles Sampled in Industrial and Residential Areas of Taif, Saudi Arabia. Aerosol Air Qual. Res. 13: 1356-1364. https://doi.org/10.4209/aaqr.2012.11.0320


 

ABSTRACT


This paper describes the first part of a project conducted to evaluate the trace element composition of atmospheric aerosol particles (PM2.5) and to determine their influence on air quality in Taif city, Saudi Arabia. PM2.5 particles were collected from two different sites (industrial and residential) in Taif during the summer of 2011. The industrial site was situated in the largest industrial area of Taif, and the residential site was situated in the city’s most crowded area. PM2.5 samples were collected on polycarbonate filters using a cyclonic collector. Each sample was collected over a 24 hour period and new samples were collected weekly. Average PM2.5 concentrations of 47 ± 15 and 46 ± 31 µg/m3 were seen in the industrial and residential areas, respectively. An Energy Dispersive X-ray Fluorescence (EDXRF) spectrometer with a Mo secondary target was used to analyze the solid samples because of the relative simplicity of the technique for filter analysis. The use of a Mo secondary target is advantageous, because it decreases the impact of continuum radiation from the X-ray tube and increases the signal to background ratio. Quantitative X-ray Analysis Software (PyMca) was used to perform quantitative analysis of the atmospheric aerosols. The analysis resulted in detected concentrations for sixteen elements; Si, S, Cl, K, Ca, Ti, Cr, Mn, Fe, Ni, Cu, Zn, Rb, Sr, Pb and Black Carbon (BC). Using Principal Component Analysis (PCA) it was possible to distinguish between natural and anthropogenic sources. The measured concentrations of the potentially hazardous trace elements Cu, Cr, Mn, Ni and Pb were below the limits defined by international guidelines and national standards for ambient air quality. However, further long-term research will be required to validate the quantification of trace elements in particulate matter in Taif.


Keywords: Aerosol particles; PM2.5; Metals; EDXRF; Trace element determination


Share this article with your colleagues 

 

Subscribe to our Newsletter 

Aerosol and Air Quality Research has published over 2,000 peer-reviewed articles. Enter your email address to receive latest updates and research articles to your inbox every second week.

8.3
2023CiteScore
 
 
79st percentile
Powered by
Scopus
 
   SCImago Journal & Country Rank

2023 Impact Factor: 2.5
5-Year Impact Factor: 2.8

Aerosol and Air Quality Research partners with Publons

CLOCKSS system has permission to ingest, preserve, and serve this Archival Unit
CLOCKSS system has permission to ingest, preserve, and serve this Archival Unit

Aerosol and Air Quality Research (AAQR) is an independently-run non-profit journal that promotes submissions of high-quality research and strives to be one of the leading aerosol and air quality open-access journals in the world. We use cookies on this website to personalize content to improve your user experience and analyze our traffic. By using this site you agree to its use of cookies.