Hsing-Cheng Hsi 1, Mark J. Rood2, Massoud Rostam-Abadi2,3, Yu-Min Chang1

  • 1 Institute of Environmental Engineering and Management, National Taipei University of Technology, No. 1, Sec. 3, Chung-Hsiao E. Rd., Taipei 106, Taiwan
  • 2 Department of Civil and Environmental Engineering, University of Illinois, 205 N. Mathews Ave., Urbana, IL 61801, USA
  • 3 Illinois State Geological Survey, 615 E. Peabody Dr., Champaign, IL 61820, USA

Received: July 10, 2012
Revised: November 19, 2012
Accepted: November 19, 2012
Download Citation: ||https://doi.org/10.4209/aaqr.2012.07.0177  

  • Download: PDF

Cite this article:
Hsi, H.C., Rood, M.J., Rostam-Abadi, M. and Chang, Y.M. (2013). Effects of Sulfur, Nitric Acid, and Thermal Treatments on the Properties and Mercury Adsorption of Activated Carbons from Bituminous Coals. Aerosol Air Qual. Res. 13: 730-738. https://doi.org/10.4209/aaqr.2012.07.0177



The influences of sulfur, HNO3, and thermal treatments on the properties and Hg adsorption of activated carbon (AC) derived from bituminous coals were evaluated. These ACs were impregnated with either polysulfide or elemental sulfur at 120, 200, and 600°C. Additional ACs were treated with HNO3 at 95°C to incorporate oxygen functionalities, and then subjected to temperature-programmed desorption to 950°C to remove surface oxygen groups and create nascent active sites on the AC surface. Polysulfide and elemental sulfur impregnation at < 200°C did not improve adsorption. However, improvement in HgCl2 adsorption by up to 97% was observed. Elemental sulfur impregnation at 600°C enhanced Hg0 and HgCl2 adsorption by up to 42% and 404%, respectively, for ACs derived from a low-organic-sulfur coal. Improvements in Hg0 adsorption for ACs from high-organic-sulfur coals were not observed after sulfur impregnation. HNO3 and thermal treatments reduced Hg-active groups such as sulfur. Oxygen surface groups and the nascent carbon sites appeared to be more reactive towards other flue gas components than Hg, because HNO3 and thermal treatments led to a reduction in Hg0 and HgCl2 adsorption. These results suggest that AC’s physical and chemical properties after sulfur treatment influence Hg0 adsorption, while HgCl2 adsorption is mainly affected by AC’s chemical characteristics.

Keywords: Mercury; Sulfur; Thermal treatment; Adsorbent; HNO3

Share this article with your colleagues 


Subscribe to our Newsletter 

Aerosol and Air Quality Research has published over 2,000 peer-reviewed articles. Enter your email address to receive latest updates and research articles to your inbox every second week.

77st percentile
Powered by
   SCImago Journal & Country Rank

2022 Impact Factor: 4.0
5-Year Impact Factor: 3.4

Aerosol and Air Quality Research partners with Publons

CLOCKSS system has permission to ingest, preserve, and serve this Archival Unit
CLOCKSS system has permission to ingest, preserve, and serve this Archival Unit

Aerosol and Air Quality Research (AAQR) is an independently-run non-profit journal that promotes submissions of high-quality research and strives to be one of the leading aerosol and air quality open-access journals in the world. We use cookies on this website to personalize content to improve your user experience and analyze our traffic. By using this site you agree to its use of cookies.