Yi Yang 1, Ping Mao1, Chun-lan Xu1, Shou-wen Chen2, Jin-hua Zhang2, Zheng-ping Wang2

  • 1 School of Chemical Engineering, Nanjing University of Science and Technology, Nanjing 210094, China
  • 2 School of Environmental and Biological Engineering, Nanjing University of Science and Technology, Nanjing 210094, China

Received: April 7, 2011
Revised: June 5, 2011
Accepted: June 5, 2011
Download Citation: ||https://doi.org/10.4209/aaqr.2011.04.0038  

  • Download: PDF

Cite this article:
Yang, Y., Mao, P., Xu, C.l., Chen, S.w., Zhang, J.h. and Wang, Z.p. (2011). Distribution Characteristics of nano-TiO2 Aerosol in the Workplace. Aerosol Air Qual. Res. 11: 466-472. https://doi.org/10.4209/aaqr.2011.04.0038



In this study, the distribution characteristics of nano-TiO2 aerosol have been studied to get insight of the suspension, agglomeration and depositing performances of aerosol nanoparticles in the workplace. The number concentration and mass concentration of the aerosols have been characterized by using a wide-range particle spectrometer and cascade impactor samplers, respectively. Water based wet aerosol samplers, as well as its corresponding analysis approaches based on ultraviolet spectrometry, have also been developed to investigate the mass concentration and present an efficient sampling performance with the quite shorter sampling time than that by cascade impactors. To get a comparison of the test results with each other, sampling points have been set at the heights of breathing zone (1.0, 1.5 and 2.0 m) and at the distances of 1 to 5 m away from the discharge port of the assembly line. It is found that all the number concentration curves exhibit two peaks at the ranges of 10–200 nm and 500–900 nm. The aerosol particles with distance of 3 m exhibit the highest number concentration at all the diameter range except for the diameter less than 20 nm. While, aerosol at the distance of 5 m presents the highest number concentration, up to 18000 particles per cm3, in the diameter less than 20 nm. It is attributed to the spray forces of the discharge port and the suspending and depositing of aerosol nanoparticles in the air. The mass concentration and particle weight percentage at different diameter tested by cascade impactor show a strong dependence on the number concentration, which is well consistent with the results obtained by wet method.

Keywords: Aerosol nanoparticles; Mass concentration; Number concentration; Titanium dioxide; Workplace

Share this article with your colleagues 


Subscribe to our Newsletter 

Aerosol and Air Quality Research has published over 2,000 peer-reviewed articles. Enter your email address to receive latest updates and research articles to your inbox every second week.

77st percentile
Powered by
   SCImago Journal & Country Rank

2022 Impact Factor: 4.0
5-Year Impact Factor: 3.4

Call for Papers for the special issue on: "Carbonaceous Aerosols in the Atmosphere"

Aerosol and Air Quality Research partners with Publons

CLOCKSS system has permission to ingest, preserve, and serve this Archival Unit
CLOCKSS system has permission to ingest, preserve, and serve this Archival Unit

Aerosol and Air Quality Research (AAQR) is an independently-run non-profit journal that promotes submissions of high-quality research and strives to be one of the leading aerosol and air quality open-access journals in the world. We use cookies on this website to personalize content to improve your user experience and analyze our traffic. By using this site you agree to its use of cookies.