Jianwu Shi1, Yue Peng2, Weifang Li1, Weiguang Qiu2, Zhipeng Bai 1, Shaofei Kong1, Taosheng Jin1

  • 1 State Environmental Protection Key Laboratory of Urban Ambient Air Particulate Matter Pollution Prevention and Control, College of Environmental Science and Engineering, Nankai University, Tianjin 300071, China
  • 2 Liaoning Provincial Environmental Monitoring Center, Shenyang 110031, China

Received: December 29, 2016
Revised: September 30, 2010
Accepted: September 30, 2010
Download Citation: ||https://doi.org/10.4209/aaqr.2010.06.0050 

  • Download: PDF


Cite this article:
Shi, J., Peng, Y., Li, W., Qiu, W., Bai, Z., Kong, S. and Jin, T. (2010). Characterization and Source Identification of PM10-bound Polycyclic Aromatic Hydrocarbons in Urban Air of Tianjin, China. Aerosol Air Qual. Res. 10: 507-518. https://doi.org/10.4209/aaqr.2010.06.0050


 

ABSTRACT


PM10 samples were collected at six sampling sites in city center of Tianjin from April 2008 to January 2009. The concentrations of 17 selected polycyclic aromatic hydrocarbons (PAHs) in PM10 were quantified. Spatial and seasonal variations of PAHs were characterized. The dominant PAHs in PM10 samples were fluoranthene, pyrene, benz[a]anthracene, phenanthrene, chrysene, benzo[b]fluoranthene, anthracene, indeno[1,2,3-cd]pyrene and benzo[a]pyrene, accounting for above 85% of total PAHs. The total PAHs concentrations of the six sampling sites ranged from 23.4 to 513 ng/m3. Spatial variations were predominantly due to the different strengths of source emission. The total PAHs concentrations at Dongli Monitoring Station (DL) site and Beichen Science and Technology Park (BC) site were higher than those at other four sites in heating period, while those at Meijiang community (MJ) site and Beichen Science and Technology Park (BC) site were higher in no-heating period. Higher PAHs concentrations during heating period and lower concentrations during no-heating period were observed at the six sampling sites, which may be caused by the stronger emissions from stationary combustion sources in heating period and the quicker air dispersion, washout effects, photo-degradation and higher percentage in the air in vapor phase in no-heating period. The PAHs concentrations in gaseous phase were predicted with gas/particle partition model, and the BaP and BaP equivalency results indicated that the health risk of gas and particle phase PAHs to human in Tianjin were higher than that in other cities. The contributions from potential sources to PAHs in PM10 were estimated by the diagnostic ratios between PAHs and principal component analysis (PCA). In whole sampling period, coal combustion was found to the predominant contributor of PM10-bound PAHs, followed by vehicles emission and wood combustion.


Keywords: PAHs; PM10; Diagnostic ratios; PCA; Sources


Latest Articles

Impact Factor: 2.735

5-Year Impact Factor: 2.827


SCImago Journal & Country Rank

Enter your email below to receive latest published articles in your field.