Chih-Hao Perng, I-Li Cheng Cheng, I-Ching Wang, Ming-Shean Chou

  • Institute of Environmental Engineering, National Sun Yat-Sen University, Kaohsiung 80424, Taiwan, ROC

Received: June 8, 2010
Revised: January 6, 2011
Accepted: January 6, 2011
Download Citation: ||  

  • Download: PDF

Cite this article:
Perng, C.H., Cheng, I.L.C., Wang, I.C. and Chou, M.S. (2011). Ozonation of Odorous Compounds in Gases Emitted from Rubber Processing Industries. Aerosol Air Qual. Res. 11: 51-58.



This study aimed at the removal of odorous compounds in gases emitted from rubber processing industries. Simulated odorous gas for test was prepared by mixing fresh air and an odorous gas drawn from an oven in which a sample of rubber powder was kept either at 160°C (for a thermal plastic rubber) or 200°C (for a thermal setting rubber). The prepared odorous gas was then premixed with a definite amount of ozone-enriched air and introduced into a contact system. The contact system consists of two sieve-plate columns connected in series and each column has four 1-L chambers. Depending on with or without introducing circulating scrubbing water into the columns, the oxidation reaction could be either wet or dry one.

Results indicate the wet oxidation got better performances than the dry one. The former got 97 and over 90% removal of VOCs (volatile organic compounds) and odorous intensity removal, respectively, with the operation conditions of initial ozone concentration 4.0 ppm, THC (total hydrocarbon) concentrations 6.5–10.3 ppm (methane equivalent), oxidation temperature 37.3°C, gas empty bed retention time (EBRT) 12 s, and liquid/gas rate ratio 0.01 m3/m3. With conditions similar to those cited above, odor concentration (dilutions to the threshold, D/T) in the test gas could be reduced from 1,738–3,090 to 31–98 with EBRTs of 11.4–14.5 s. Activated carbon is effective for both physical and chemical removals of residual VOCs, odorous compounds, and ozone in the effluent gas from the ozonation system. Economical analysis indicates that around US$ 0.16 is required for treating 1,000 m3 of the tested foul gas by the proposed ozonation process.

Keywords: Odor control; Rubber processing; Ozone oxidation; Olfactometry

Don't forget to share this article 


Subscribe to our Newsletter 

Aerosol and Air Quality Research has published over 2,000 peer-reviewed articles. Enter your email address to receive latest updates and research articles to your inbox every second week.

Latest coronavirus research from Aerosol and Air Quality Research

2018 Impact Factor: 2.735

5-Year Impact Factor: 2.827

SCImago Journal & Country Rank

Aerosol and Air Quality Research (AAQR) is an independently-run non-profit journal, promotes submissions of high-quality research, and strives to be one of the leading aerosol and air quality open-access journals in the world.