Adam J. Mohs, Frank M. Bowman

  • Department of Chemical Engineering, University of North Dakota, 241 Centennial Drive Stop 7101, Grand Forks, ND 58202-7101, USA

Received: June 4, 2010
Revised: November 1, 2010
Accepted: November 1, 2010
Download Citation: ||https://doi.org/10.4209/aaqr.2010.06.0046  

  • Download: PDF


Cite this article:
Mohs, A.J. and Bowman, F.M. (2011). Eliminating Numerical Artifacts When Presenting Moving Center Sectional Aerosol Size Distributions. Aerosol Air Qual. Res. 11: 21-30. https://doi.org/10.4209/aaqr.2010.06.0046


 

ABSTRACT


A number of atmospheric aerosol models use the moving center sectional (MCS) method to represent the aerosol size distribution. Distributions generated via MCS may exhibit numerical artifacts during condensational growth which appear as extraneous “pits” and “peaks” in the distribution. The use of remapping and smoothing methods to eliminate these numerical artifacts when presenting size distribution results is examined. Three remapping methods based on linear interpolation and two smoothing approaches were tested for use on output distributions from MCS simulations. Model predictions of condensational growth using the MCS method with and without smoothing and remapping are compared to an accurate analytical solution. Results indicate that one remapping method, the zero mass exclusive method, completely removed “pits” and “peaks” that form in high resolution, 48-section distributions, whereas the other potential correction methods only partially removed the artifacts. For lower resolution 12-section distributions, where pits and peaks are not formed, the remapping methods provide smaller improvements in how MCS distributions are depicted and smoothing approaches result in significant numerical diffusion.


Keywords: Modeling; Condensational growth; Artifact correction; Aerosol size structure

Don't forget to share this article 

 

Subscribe to our Newsletter 

Aerosol and Air Quality Research has published over 2,000 peer-reviewed articles. Enter your email address to receive latest updates and research articles to your inbox every second week.